Load Menu From Usb; Save Menu To Usb; Firmware Update - TurboChef ECO Owner's Manual

Hide thumbs Also See for ECO:

Table of Contents

3. Once installation is complete, the oven will

display "Installation Complete."

NOTE: To save a copy of the oven menu, you may

need to verify that access to the Load Menu screen is

turned on. See page 25 for details.

If desired, name the menu from the Menu Info screen

to make it easy to find on your USB drive. See page 14.

1. When the oven is off or cooling down, insert the

USB (see below). The oven will automatically

detect the device. Touch "OK" to proceed.

2. Touch "Save Menu to USB."

3. Touch "OK" to begin saving the menu to the USB.

Touch "CANCEL" to go back to the previous screen.

4. Once installation is complete, the oven will

display "Save Complete."

NOTE: The menu file will be saved in the root

directory on the USB.

TurboChef may at some point recommend a

firmware update. The update will make sure your

oven is operating at its maximum efficiency, but

should not affect cooking results or menu settings.

CAUTION: Do not remove the USB until

"Installation Complete" is displayed.

1. When the oven is off or cooling down, insert the

USB (see below). The oven will automatically

detect the USB. Touch "OK" to proceed.

2. Load the firmware:

a. Touch "Update Firmware."

b. Touch "OK" to confirm the selection.

3. The oven will install each firmware file included

with the update. Once installation is complete,

the oven will display "Installation Complete."

ECO-1001 / Revision G / August 2023

Table of Contents