Table of Contents
Advertisement
WARNING: This oven is not intended for
built-in installation (i.e., installing the oven in
any structure that surrounds the oven by five or
more sides). Be sure to provide a minimum of 2"
(51 mm) clearance for all sides and 5" (127 mm)
clearance for the top.
WARNING: This oven is not intended to be
stacked without appropriate hardware.
Never stack ovens more than two high.
Installing the Oven
1. Prepare a surface at least 23.5" (597 mm) deep
and capable of supporting 120 lb. (54 kg).
2. Position one or more persons at the front and
back of the oven.
3. Place hands under the oven and lift.
4. Place the oven on the prepared surface, ensuring
no edges are hanging off the sides.
5. If stacking two ovens:
a. See page 1 for dimensions.
b. Install the stacking bracket (part number
ENC-3001) to the lower oven.
c. Place the upper oven on top of the lower oven.
d. Secure the bracket to the top oven.
Partition
Height equal
to oven height
Grill
Figure 2: Installation Near Open Heat Source
6. Ensure the oven rack is properly installed to each
oven (attached to the bottom jetplate).
7. Ensure the lower panel (crumb tray) is attached
below the oven door.
8. Plug in the oven.
NOTE: The oven is primarily serviced through
its sides and top. Shelving installed directly over
the unit may delay servicing. The owner will be
responsible for paying service costs for additional
time spent accessing the oven.
Installation Near Open Heat Source
When placing a TurboChef oven near an open heat
source (Figure 2), strictly adhere to the following:
- If the oven is being placed near a grill or stove, a
divider must exist between the oven and the open
heat source, with a minimum of 6" (153 mm)
between the oven and the divider.
- If the oven is being placed near a fryer, a divider must
exist between the oven and fryer, with a minimum of
12" (305 mm) between the oven and the divider.
- The height of the divider must be greater than or
equal to the height of the oven, 21.5" (546 mm).
- Verify the oven location has a minimum 5" (127 mm)
clearance on top and a minimum 2" (51 mm)
clearance on each side.
TurboChef
Eco Oven
6"
(153 mm)
Minimum
Counter Top / Table
Partition
Height equal
to oven height
Deep Fryer
12"
(305 mm)
Maximum
ECO-1001 / Revision G / August 2023
3
Advertisement
Table of Contents
