Recipe Mode - TurboChef ECO Owner's Manual

Recipe Mode: OneTouch Controller
The oven is preprogrammed with recipe settings at the time of manufacture and is ready to operate out of the
box. New menu settings can be loaded via USB (page 13) or programmed manually (page 11). If settings are
not present, the oven will cook only in manual mode (page 11).
This oven uses impingement and microwave to cook food faster than traditional cooking methods. Air enters
the cavity from the top and bottom using a single fan. Because of this design and to ensure uniformity of
cooking, the oven must be operated only while the bottom jetplate is in place. While the bottom jetplate is
removable for cleaning, it is not removable for cooking. Without the bottom jetplate in place, the oven will
not deliver the proper cooking performance to either the top or bottom of the food item. Additionally, oven
damage may result.
The sequence of the steps below may vary, and some may not apply.
Step 1: Touch the Power Icon in the center of the screen to begin preheat.
Figure 7: Power Icon
Step 2: Select a group to select a set temperature.
Figure 8: Group/Temperature Selection
Step 3: Preheat Progress
Figure 9: Preheat
NOTE: The legacy controller has universal temperatures. The
OneTouch controller allows temperature to be set per recipe, and
then like-temperature recipes to be added to groups. If multiple
groups contain the same set temperature, then select any one of them
to preheat. Until a group is selected, the oven will preheat to the
lowest set temperature in the menu.
NOTE: When the oven is done warming up, it will "soak" for an
additional eight minutes. "Soaking" ensures the cavity surfaces absorb
enough heat so that cooking will not be affected.
While the oven is preheating, you can touch the "Recipes" button to
view recipes or select a new group.
ECO-1001 / Revision G / August 2023
9