Lcd Monitor Message; Stationary Pto - Kubota B2650 Operator's Manual

44 PTO
Model [B2650/B3350/B3350SU]
BLCD Monitor Message
1. The PTO rpm can be checked in the LCD monitor.
(See "LCD MONITOR" in "OPERATING THE
TRACTOR" section.)
(1) LCD monitor
(2) PTO indicator
(3) PTO speed
A With the PTO in the "ON" position, a numeric value is
displayed on the LCD monitor even if the PTO shaft is
not turning.
BStationary PTO
To park the tractor and use the PTO system (for chipper
or pump, for example), start the PTO system in the
following steps.
1. Apply the parking brake and place blocks at the tires.
2. Make sure the shift levers are at NEUTRAL, and start
the engine.
3. Set the PTO select lever to rear only position. [B2650/
B3350 only]
4. Set the PTO clutch lever to engage "ON".
5. Set the engine speed to provide recommended rear
PTO speed.
6. Get off the tractor.
(1) Parking brake lever
(1) PTO clutch lever
(2) PTO select lever
[B2650/B3350 only]
A If the PTO system is engaged and you stand up from
the seat and release the parking brake, the engine
stops automatically after standing up.
(A) Interlock the brake pedals
(B) "DEPRESS"
(C) "PULL DOWN"
"ON"
"OFF"