Table of Contents
Advertisement
Chapter 16
All devices or the specific device on the internet can log in to your mesh device using
the address displayed on the
the mesh device.
Tips:
1. If you were warned about the certificate when visiting the web management page remotely, click
option) to continue. To avoid this warning, you can download and install the certificate on the mesh device's web
management page at
Advanced
2. The mesh device's WAN IP is usually a dynamic IP. Please refer to
the mesh device through a domain name.
16 7 4
HTTP Referer Head Check
HTTP referer header check function can protect your networks against CSRF attacks.
This function is enabled by default. You can disable this function if needed.
1
Visit
http://tplinkwifi.net
set for the mesh device.
2
Go to
Advanced
Head Check
section.
3
Clear the
Enable
16 7 5
ICMP Ping
ICMP (Internet Control Message Protocol) Ping is used to diagnose the network by
sending ICMP echo request packets to the target remote or local host and waiting for
an ICMP response.
You can control the mesh device's replies to ICMP Ping requests.
1
Visit
http://tplinkwifi.net
set for the mesh device.
2
Go to
Advanced
Manage This Mesh Device via the Address
>
System Tools
> Administration.
or http://192.168.88.1, and log in with the password you
>
System Tools
> Administration, and locate the
check box and click
or http://192.168.88.1, and log in with the password you
>
System Tools
> Administration, and locate the
Configure IPv6 LAN Settings
Save
if you want to disable this function.
Manage Your Mesh Device
field to manage
Trust
(or a similar
if you want to log in to
HTTP Referer
ICMP Ping
section.
137
Advertisement
Table of Contents
