Table of Contents
Advertisement
Chapter 16
Note:
If you want all local devices can manage the mesh device, just leave the
16 7 3
Remote Management
By default, the remote devices are not allowed to manage the mesh device from the
internet. You can enable remote management over HTTP and/or HTTPS if needed.
HTTPS is a more secure way to access the mesh device.
Note:
If your ISP assigns a private WAN IP address (such as 192.168.x.x or 10.x.x.x), you cannot use the remote management
feature because private addresses are not routed on the internet.
Follow the steps below to allow remote devices to manage the mesh device over HTTPS.
1
Visit
http://tplinkwifi.net
set for the mesh device.
2
Go to
Advanced
Management
section.
3
Enable
Remote Management
HTTPS connection. Keep the
4
Set the client device allowed for remote management. Select
devices to manage the mesh device. If you just want to allow a specific device to
manage the mesh device, select
IP/MAC address of the remote device.
5
Click Save.
or http://192.168.88.1, and log in with the password you
>
System Tools
> Administration, and locate the
and
Remote Management via HTTPS
Port
as the default setting.
Only the Following IP/MAC Address
Manage Your Mesh Device
IP/MAC Address
field blank.
All
to allow all remote
Remote
to allow for
and enter the
136
Advertisement
Table of Contents
