Check Ont Status; Configuring Bridging Ont - TP-Link GPON OLT P1200-08 Configuration Manual

If multiple ONTs of the same type bound to the same line profile or service profile are connected to
the same port, you can add ONTs in bulk by confirming all the automatically discovered ONTs to
make configuration easier and more efficient. To do so, the preceding command can be modified
as follows:：
OLT(interface-gpon)# ont confirm 4 all sn-auth ont-lineprofile-id 10 ont-srvprofile-id 10.

5.4 Check ONT Status

After an ONT is added, run the show ont info command to query the current status of the ONT.
Ensure that Config flag of the ONT is active, Run State is online, Config state is success, and
Match state is match.
OLT(interface-gpon)# show ont info 4 2
-----------------------------------------------------------------------------
PORT-ID: 4
ONT-ID : 2
Control flag : Active
Run state : Online
Config state : Success
Match state : Match
...// he rest of the response information is omitted.
When Config state is failed, Run state is offline, or Match state is mismatch:
If Control flag is deactive, run the ont active command in GPON mode to activate the ONU.

If Run state is offline, a physical line may be broken or the optical module may be damaged.

Check the line and the optical module.
If Config state is failed, the configured ONU capability exceeds the actual ONU capability.

If the ONU does not match, that is, Match state is mismatch, the port types and number of

ports do not match the actual port types and number of ports supported by the ONU. In this
case, run the show ont capability command to query the actual capability of the ONU, and
then select right one.
5.5 Configuring SFU (Bridge ONT)
This topic describes how to configure Internet access service when SFU is used to build an FTTH
network.
Prerequisites
The OLT is connected to the uplink device successfully

The ONT has been added to the OLT. For details, see chapter 4.3.

The VLAN of the LAN switch port connected to the OLT uplink port is the same as the uplink

VLAN of the OLT.
Data Plan
Item
ONT Line Profile Line Profile: 10
10
Data