Table of Contents
Advertisement
Chapter 6
Done!
•
Network Destination:
to assign to a static route. This IP address cannot be on the
same subnet with the WAN IP or LAN IP of the Mesh Device A.
In the example, the IP address of the company network is the
destination IP address, so here we enter 172.30.30.1.
•
Subnet Mask:
Determines the destination network with the
destination IP address. If the destination is a single IP address,
enter 255.255.255.255; otherwise, enter the subnet mask of
the corresponding network IP. In the example, the destination
network is a single IP, so here we enter 255.255.255.255.
•
Gateway:
The IP address of the gateway device to which the
data packets will be sent. This IP address must be on the same
subnet with the mesh device's IP which sends out the data. In
the example, the data packets will be sent to the LAN port of
Mesh Device B and then to the Server, so the default gateway
should be 192.168.88.2.
•
Interface:
Determined by the port (WAN/LAN) that sends
out the data packets. In the example, the data is sent to the
gateway through the LAN port of Mesh Device A, so
should be selected.
5 Select the
Enable This Entry
6 Click
Save
to make the settings effective.
Open a web browser on your PC. Enter the company server's IP
address to visit the company network.
Customize Your Network Settings
The destination IP address that you want
check box to enable this entry.
LAN
57
Advertisement
Table of Contents
