Installing The Belt Cover - Toro E-Z Vac 78566 Operator's Manual

11. Join the upper and lower tubes with 3 bolts (#10 x
3/4 inches), 3 flat washers (7/32 inch), and 3 locknuts
(#10) as shown in Figure
Figure 28
1. Lower tube
2. Upper tube
3. Flat washer (7/32 inch)
12. Install the lower tube onto the blower housing and
secure it with the latches.
11

Installing the Belt Cover

Parts needed for this procedure:
1 Belt cover (from the Blower and Drive Kit)
Procedure
1. Lower the mower deck to the lowest height-of-cut
position.
2. Install the new belt cover so that the notches on both
sides go over the belt-cover supports and secure the
latch (Figure 29 or
28.
4. Locknut (#10)
5. Bolt, (#10 x 3/4 inches)
Figure 30).
48- and 52-inch bagger shown
1. Belt cover
2. Belt-cover support
60- and 72-inch bagger shown
1. Belt cover
2. Belt-cover support
19
1
2
Figure 29
3. Notch
1
2
G009303
Figure 30
3. Notch
G009305