Adjusting The Open Door For 48- And 52-Inch Mowers - Toro E-Z Vac 78566 Operator's Manual

Adjusting the Open Door for
48- and 52-inch Mowers
Perform this after adjusting the closed door.
1. Remove the side plate from both sides of the bagger
(Figure 54).
1. Bolt
2. Washer
2. Open the door.
3. Check the distance between the upper tube of the door
frame and the lower lip of the molded hood
Note: The distance should be between 3.2 mm (1/8
inch) and 9.6 mm (3/8 inch).
Figure 54
3. Side plate
(Figure
1. Lower lip of the molded
hood
2. The measurement is
between an 3.2 mm (1/8
inch) and 9.6 mm (3/8
inch).
4. If adjustment is needed, adjust the hinge stops on both
sides so that the distance between the upper tube of
the door frame and the lower lip of the molded hood is
between an 3.2 mm (1/8 inch) and 9.6 mm (3/8 inch).
Note: Make sure that both the left and right hinge
stops are adjusted the same distance.
5. Tighten the nuts and install the side plates.
55).
1. Hinge stop
33
Figure 55
3. Upper tube of the door
frame
Figure 56
2. Nut