Adjusting The Closed Door For 48- And 52-Inch Mowers - Toro E-Z Vac 78566 Operator's Manual

Figure 51
1. Bolt
2. Washer
4. Check the distance between the left and right bellcranks
and the upper frame tube.
Note: These dimensions need to be the same on both
sides.
5. To make the distances equal, loosen the Allen-head
bolt on the hub of the right bellcrank
6. Position the bellcrank arms the same distance from
the upper frame tube.
7. Tighten the Allen-head bolt and install the side plates.
Figure 52
1. Right bellcrank arm
2. Allen-head bolt
3. Side plate
(Figure 52).
3. Distance from the
bellcrank arm and upper
frame tube is the same on
both sides.
4. Upper frame tube
Adjusting the Closed Door for
48- and 52-inch Mowers
1. Disengage the PTO, move the motion-control levers
to the N
EUTRAL
brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. With the door closed, check and ensure that it is slightly
tight against the frame when closed.
4. If adjustment is needed, adjust the nuts.
Note: Lengthen the links to reduce the force. Shorten
the links to increase the force.
Note: Make sure that both the left and right sides are
adjusted the same distance. With the door closed, the
links should be slightly tight to minimize rattling.
5. Tighten the nuts.
1. Door
2. Hinge link
32
- position, and set the parking
LOCKED
Figure 53
3. Nut