9
Installing the Belt Cover
Parts needed for this procedure:
1
Belt cover (from Blower and Drive Kit)
Procedure
1.
Lower the mower deck to the lowest height-of-cut
position.
2.
Install the new belt cover so that the notches on
both sides go over the belt-cover supports and
secure the latch
(Figure 31
Figure 31
48- and 52-inch bagger shown
1. Belt cover
2. Belt-cover support
or
Figure
32).
g009305
3. Notch
60- and 72-inch bagger shown
1. Belt cover
2. Belt-cover support
10
Installing the Weights
Parts needed for this procedure:
2
Caster weight (if needed)
2
Clevis pin
2
Hairpin cotter
6
Lock washer (3/8 inch)
1
Weight-mount bracket
6
Bolt (3/8 x 1-1/2 inches)
6
Flat washer (3/8 inch)
3
Carriage bolt (5/16 x 3/4 inch)
3
Flange nut (5/16 inch)
3
Front weight (48-inch, 52-inch, and 60-inch decks)
Front weight [72-inch decks (serial number 406294344
1
and below)]
Front weight [72-inch decks (serial number 406294345
2
and above)]
Procedure
To comply with ANSI/OPEI B71.4-2012 Standard, add
weights to the machine.
19
Figure 32
3. Notch
g009303