6
Installing the Bagger
Assembly
Parts needed for this procedure:
1
Bagger assembly
2
Pin and hairpin cotter assembly
Procedure
1. Position the bagger on its back
2. Slide the hooks onto the lower mounting bracket
(Figure
10).
3. Rotate the bagger up on the lower bagger mounting
bracket.
4. Align the hole in the bagger with the upper mounting
bracket
(Figure
10).
5. Install the pin and secure it with the hairpin cotter on
both sides
(Figure
10).
(Figure
10).
11
Figure 10
1. Lower mounting bracket
2. Hook
3. Bagger
6. Rotate the bagger-handle linkage up to the bagger
assembly and secure it with a clevis-pin spring
11).
Note: Loosen and rotate the yoke if needed to align it
with the bagger assembly.
4. Rotate bagger up
5. Hairpin cotter connected
to lanyard
6. Pin connected to lanyard
(Figure