Preparing The Machine; Installing The E-Z Vac Blower And Drive Kit; Installing The Blower Assembly, Belt, And Belt Cover - Toro E-Z Vac 78570 Operator's Manual

1

Preparing the Machine

No Parts Required
Procedure
Note:
Remove the Roller Striper Kit, if installed, prior
to installing this attachment.
1. Disengage the PTO, move the motion-control
levers to the N
EUTRAL
engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Repair all bent or damaged areas of mower
deck and replace any missing parts.
4. Clean the machine of any debris on the deck or
rear part of the machine to ease installation.
2
Installing the E-Z Vac
Blower and Drive Kit
Parts needed for this procedure:
1 E-Z Vac Blower and Drive Kit (sold separately)
Procedure
Refer to the Installation Instructions for the kit.
- position, and
LOCK
3
Installing the Blower
Assembly, Belt, and Belt
Cover
Parts needed for this procedure:
1 Blower assembly (from the Blower and Drive Kit)
1 Belt (from the Blower and Drive Kit)
1 Belt cover (from the Blower and Drive Kit)
1 Knob (from the Blower and Drive Kit)
Procedure
1. Lower the mower deck to the lowest setting.
2. Remove the pulley from the blower assembly
(Figure 4).
1. Blower assembly
2. Pulley
3. Insert the pin from the blower assembly into the
blower mount bracket as shown in
7
Figure 4
3. Hex nut
Figure
g038469
5.