Table of Contents
Advertisement
Adjusting the Open Door for
60- and 72-inch Mowers
Note: Perform this procedure after adjusting the door to
completely close.
Adjust the handle link to so that the door opens as much as
possible(Figure 48
and
Figure
Note: Lengthen the handle link to open the door farther.
Shorten the handle link to open the door less
Note: How far the door opens is controlled by the contact
arm hitting the stop. The stop is not adjustable and prevents
the door from being opened too far.
1. Handle
2. Handle link
1. Handle assembly
2. Bagger-handle link
49).
Figure 48
3. Stop
Figure 49
3. Clevis-pin spring
Adjusting the Latches for 60-
and 72-inch Mowers
Note: Adjust the open door and closed door positions
before adjusting the latches.
1. Disengage the PTO, move the motion-control levers
to the N
EUTRAL
brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Close the door.
4. Ensure that the latches completely engage and contacts
the latch rod welded to the door
Note: The latches need to be tight against the latch
rod. They need to be loose enough to move or wiggle.
1. Latch link
Adjusting the Arm Position for
48- and 52-inch Mowers
The left and right bellcrank arms need to be equally positioned
from the upper frame tube for proper use.
1. Disengage the PTO, move the motion-control levers
to the N
EUTRAL
brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove the side plate from both sides of the bagger
(Figure
51).
31
-
position, and set the parking
LOCKED
(Figure
50).
Figure 50
2. Latch rod
-
position, and set the parking
LOCKED
Advertisement
Table of Contents
