Toro E-Z Vac 78566 Operator's Manual page 26

48in, 52in, 60in or 72in dfs collection system
Table of Contents

Advertisement

Reducing Plugging
To avoid plugging the bagging system, reduce the ground
speed and mow the grass at a high height-of-cut, then lower
the mower to your normal cutting height and repeat the
bagging process.
Signs of Plugging
As you use the bagger, a small amount of grass clippings
normally blow out the front of the mower. An excessive
amount of clipping blow-out indicates that the bagger is full
or the tube is plugged.
Bagging Blades
In most mowing conditions, the standard high lift blades
provides the best bagging performance.
The Toro Atomic blade is recommended for bagging leaves
in dry conditions. In dry, dusty conditions, the medium lift or
low lift blades reduces dust and dirt blowout while providing
effective bagging air flow.
Contact an Authorized Service Dealer for the proper blades
for different mowing conditions.
Curb Climbing and Loading
Always lift the deck to the highest position when loading the
machine on trailers or ascending/descending a curb. Leaving
the mower in a lower position while loading or going over a
curb can cause damage to the mower. If a curb is higher than
152 mm (6 inches), cross it at a sharp angle with the deck
fully raised. Use extreme caution when loading onto a trailer.
Use a full-width ramp; the ramp should be long enough so
that the angle does not exceed 15 degrees.
26

Advertisement

Table of Contents
loading

This manual is also suitable for:

E-z vac 78567E-z vac 78568

Table of Contents