Setup - Toro E-Z Vac 78566 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
Description
No parts required
Left bumper
Right bumper
Carriage bolt (3/8 x 1-1/4 inches)
Flange nut (large flange–3/8 inch)
Upper mounting bracket
Lower mounting bracket
Carriage bolt (3/8 x 1-1/4 inches)
Carriage bolt (1/2 x 2–1/2 inches)
Flange nut (large flange–3/8 inch)
Flange nut (1/2 inch)
Handle assembly
Handle bracket
Carriage bolt (3/8 x 1-1/4 inches)
Clevis-pin spring
Flange nut (large flange–3/8 inch)
Hood assembly
Knob
Carriage bolt
Bagger assembly
Pin and hairpin cotter assembly
Muffler deflector
Flange nut (small flange–3/8 inch)
Carriage bolt (3/8 x 1-1/4 inches)
Blower belt (from the Blower and Drive
Kit)
Blower assembly (from the Blower and
Drive Kit)
Spring (from the Blower and Drive Kit)
Upper tube
Lower tube
Bolt (#10 x 3/4 inches)
Locknut (#10)
Washer (7/32 inch)
Belt cover (from the Blower and Drive
Kit)
Qty.
–
Prepare the mower.
1
1
Install the side bumpers.
2
6
1
1
4
Install the bagger mounting brackets.
2
4
2
1
1
Install the handle assembly (for 60- and
4
72-inch mowers).
1
4
1
1 Install the hood assembly.
1
1
Install the bagger assembly.
2
1
2 Install the muffler deflector.
2
Route the blower belt into the blower
1
assembly.
1
Install the blower assembly.
1
1
1
3 Install the discharge tubes.
3
3
1 Install the belt cover.
6
Use