Figure 26
1. Lower tube
2. Upper tube
3. Flat washer, (7/32 inch)
15. Install the lower tube onto the blower housing
and secure it with the latches.
16. Install the bags onto the bagger.
Step
9
Installing the Belt Cover
Parts needed for this step:
Belt cover (from Blower and Drive Kit)
Procedure
1. Lower the mower deck to the lowest
height-of-cut position.
2. Install the new belt cover so the notches on
both sides go over the belt cover supports and
secure the latch (Figure 27).
4. Locknut, (#10)
5. Bolt, (#10 x 3/4 inches)
Figure 27
1. Belt cover
2. Blower assembly
3. Pulley assembly
4. Belt cover bracket
Step
10
Installing the Weights
Parts needed for this step:
2
Caster weight
2
U-bolt
4
Nut, (1/2 inch)
4
Lock washer, (1/2 inch)
2
Plate
2
Top weight (for 60 inch mower decks only)
2
Bolt, 1/2 x 2–1/2 inch- for top weights
Procedure
To comply with ANSI/OPEI
B71.4-2004 Standard, weights must be
added to the machine.
17
5. Latch
6. Belt cover notch
7. Belt cover support