7
Note: Maintenance procedures should be done by qualified technical personnel.
Caution: It is recommended that you fit and check a suitable anti-static wrist and conductive foam
Before You Begin
Tools and Supplies Needed
System References
Removing or Installing the Enclosure Cover
Warning: The enclosure cover must only be removed by a service personnel. Potential hazards
www.DataSheet4U.com
Intel® Entry Storage System SS4000-E User Guide
Hardware Installations and
Upgrades
This chapter provides instructions for removing, installing, and replacing storage system
components in your Intel
pad and observe all conventional ESD precautions when handling storage system
modules and components. Avoid contact with the backplane components and module
connectors.
Before working with your storage system, review the important safety information listed
in
Appendix G, "Safety
Information".
•
Phillips* (cross head) screwdriver (#1 bit and #2 bit)
•
Anti-static wrist strap and conductive foam pad (recommended)
All references to left, right, front, top, and bottom assume the reader is facing the front of
the storage system as it would be positioned for normal operation.
include:
•
Energy hazard
•
Rotating fans
•
Hot surfaces
•
Access to power supply unit openings
Upon replacement, the cover MUST be secured by tightening the retaining screw with a
screwdriver.
®
Entry Storage System SS4000-E.
Hardware Installations and Upgrades
137