Intel D39172-003 User Manual page 115

www.DataSheet4U.com
Intel® Entry Storage System SS4000-E User Guide
Recommendations:
•
If your computer has only one disk with one partition, select the disk.
•
If any partition (such as an EISA partition) precedes your system partition, select the
entire disk. This ensures that you can remotely boot from and recover the disk.
•
If your disk has a system partition and a data partition, select one of the partitions and
complete the wizard. Then run the wizard again and protect the other partition. This
provides complete protection with maximum flexibility.
However, if Intel® Client Backup and Recovery was installed on the data partition,
protect the entire disk rather than the individual partitions. This ensures that you can
remotely boot from that disk.
What To Do Next:
You never previously completed the Protect a Disk wizard
You previously completed the Protect a Disk wizard and connected to a
storage system
You previously protected this disk and removed protection (as described in
"Removing Protection" on page
3. When the Add Storage System dialog box appears, Client Backup and Recovery
automatically scans your subnet for storage systems. Any storage systems that are
detected appear in the Discovered storage systems list. (It might take a few seconds
to complete the scan. You can cancel it at any time by clicking Cancel on the scanning
message box.)
From the Discovered storage systems list, select the storage system where you want
to back up the selected disk. The name of the storage system automatically appears in
the Storage system name or IP address text box.
If you plan to remotely boot from a backup on the storage system, it is recommeded
that you select the IP address of the first port. If the DHCP server option is enabled on
your storage system, you can remotely boot only from the first port. If this option is
In this case
126)
Protecting Local Disks
Go to this step
3
4
5
99