Intel D39172-003 User Manual page 134

Protecting Local Disks
Proceed with recovering data
Load a new recovery driver
See a complete list of the
www.DataSheet4U.com
detected hardware
118
The recovery CD can recover multiple partitions to a disk with existing partitions. It can
also create one partition on a new disk. However, if you want to recover multiple
partitions to a new disk, you must format and partition the disk before you use the
recovery CD to recover the partitions.
To recover a system disk or partition using the recovery CD:
1. Using the appropriate procedure for your computer, configure it to boot from the CD-
ROM drive.
For more information, refer to the documentation for your computer.
2. Insert the recovery CD into the CD-ROM drive.
A welcome screen appears while the CD initializes.
3. If you have already verified that the recovery CD supports your local hardware, or if
you have received a new recovery driver from your vendor, wait 25 seconds for
Normal Mode to start automatically and go to step 4.
If this is the first time you have used the recovery CD, press any key to start
Diagnostic Mode. The screen displays a list of all the devices found on your
computer and whether or not they are compatible with the recovery CD. You can use
the arrow keys to scroll through the list. If at least one supported network interface
card (NIC) and one hard disk have been detected, select Normal Mode and go to step
4.
If no supported NIC is found, you can gather information about your computer and
send it to Technical Support to see if an updated recovery CD or an appropriate driver
is available. To do this, select Save, insert a formatted floppy disk or USB disk into
your computer, and select the appropriate option (Save to Floppy Disk or Save to
USB Disk). Once the file has been saved to the specified location, you can send it to
Technical Support. Then select Finish and select Yes to restart your computer. At this
point, you have 10 seconds to remove the recovery CD from your CD-ROM drive and
boot from your local disk once more. Otherwise, your computer will boot from the
recovery CD again.
4. When the hardware list appears, take the desired action:
To do this
5. Review the network settings for your NIC and select Next.
Select Next.
You can select Next only if at least one supported NIC is
listed.
Select Load Driver, select the location from which you want to
install the driver (Load From System for the local hard disk,
Load From Floppy Disk for a floppy disk, Load From CD for
a CD, or Load From USB Disk for a USB disk), insert the disk
(if loading from a floppy disk, CD, or USB disk), and respond to
the prompts.
Select Diagnostic Mode.
When you are done viewing the list, select Normal Mode.
Intel® Entry Storage System SS4000-E User Guide
Do this