Intel D39172-003 User Manual page 141

www.DataSheet4U.com
Intel® Entry Storage System SS4000-E User Guide
12. Click Restore Disk.
The Restore dialog box appears.
13. Specify whether you are recovering to the original disk or a new disk.
If you are recovering to a new disk, select the desired disk from the list. Then click
Restore.
14. When the confirmation message appears, click Yes.
The backup is recovered to your local disk, and the progress bar displays the progress
of this process. You can cancel the recovery at any time by clicking Stop on the
progress dialog box.
Note: Do not shut down your computer, disconnect from the network, or perform
any other tasks until this process is complete.
15. After the recovery is complete, click OK to restart your computer.
16. Use the appropriate procedure for your computer to configure it to boot from the local
disk once more.
17. If you changed the recovery password, reset it in the Microsoft iSCSI Initiator* after
your computer restarts (as described in
Microsoft iSCSI Initiator*" on page
18. Start Intel® Client Backup and Recovery and remove protection from all your disks
and partitions (as described in
them again (as described in
backups.
If you need to recover other data disks or partitions, you can do so (as described in
"Recovering a Data Disk" on page
removed protection and then reprotected the disks.
19. Disable remote boot (as described in
enable it again (as described in
"Resetting the Recovery Password in the
165).
"Removing Protection" on page
"Protecting Your Disks" on page
116). However, be sure to do this after you have
"Disabling Remote Boot" on page
"Enabling Remote Boot" on page
Protecting Local Disks
126). Then protect
97), reusing the existing
112) and
111).
125