Intel D39172-003 User Manual page 87

www.DataSheet4U.com
Intel® Entry Storage System SS4000-E User Guide
4. Click Reconfigure Disks.
5. When the confirmation message appears, click OK.
The Disk Configuration page appears. (The options that appear on this page vary,
depending on the number of hard disks that are currently installed in the system.)
6. If you want to add or remove hard disks, do so one at a time and click Scan after each
action. If you're adding disks, wait until the disk LED is green before you click Scan.
To accept the default disk configuration (which will provide the best level of data
protection available for the number of hard disks currently installed), click Next. By
default, a linear disk configuration is used for a single hard disk, RAID 1 is used for
two hard disks, and RAID 5 is used for three or four hard disks.
If you want to change the disk configuration, select the desired RAID level and then
click Next. (For detailed information about the different RAID levels, refer to
Appendix A, "Levels of RAID,"
Managing Your Storage System
beginning on page 169.)
71