Replacing Power Supply - Intel D39172-003 User Manual

Replacing Power Supply

Note: Replacement of the power supply should be done by qualified service personnel.
Note: Before performing any maintenance on the storage system, back up all data. Shut down
www.DataSheet4U.com
Intel® Entry Storage System SS4000-E User Guide
turn a continuous yellow, indicating a fault condition. If this occurs, remove the hard disk
from the storage system and check it or replace it with another hard disk.
When first installing hard disks to set up your storage system, the System Status LED turns
yellow to indicate that the disks are not configured.
If you replace all of the hard disks with higher-capacity hard disks, you must go to
Administrator to login and reconfigure the disks.
The power supply is located on the back of the Intel
the storage system by selecting the Advanced tab from the Manager and then Shutdown
from the left-hand menu.
1. Observe all safety and ESD precautions listed in
2. Remove the new power supply from its protective packaging.
3. If you are unable to shut down the system using the software Manager than power
down the storage system by pressing and holding the power button for approximately
five seconds until the System Status LED starts flashing. The storage system will shut
off after a short shutdown period.
4. Disconnect the storage system from its power source.
Hardware Installations and Upgrades
®
Entry Storage System SS4000-E.
Appendix G, "Safety Information".
145