Table of Contents
Advertisement
Selecting in the Waypoint list:
1.
Open the "Waypoint" screen.
[MENU] > Navigation > Waypoint
2.
Push [▲] or [▼] or rotate [CH/ENT] to select a waypoint.
L Push Sort to sort the waypoints by Name or Range.
3.
Push
NAV
.
• "Start navigation. Are you sure?" is displayed.
4.
Push
.
OK
• The plotter screen is displayed, and the transceiver starts to navigate to the waypoint.
•
is displayed on the plotter screen.
TIP: You can also start navigation in the "Detail" screen of the waypoint.
1.
Repeat steps 1 and 2.
2.
Push
, [ENT], or [CH/ENT].
Details
• The "Detail" screen is displayed.
3.
Repeat steps 3 and 4.
D Stopping navigation
Stop NAV
1.
Push
to stop navigation.
• "Stop navigation. Are you sure?" is displayed.
2.
Push
.
OK
• The transceiver stops to navigate, and then returns to
the previous screen.
D Resetting navigation
The transceiver resets the start position, and restarts navigation from your current
position.
L The function works only when the transceiver is receiving valid GPS signals.
L The function cannot work while in the MOB mode, or when the transceiver does not
navigate.
1.
Open the "Navigation" screen.
[MENU] > Navigation
2.
Push "Reset navigation" to reset the start position.
• "Reset navigation. Are you sure?" is displayed.
OK
3.
Push
.
• The transceiver resets the start position, and restarts
navigation from your current position.
OTHER FUNCTIONS
9
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
68
Advertisement
Table of Contents
