Table of Contents
Advertisement
2.6
INFORMATION MENU
Information menu
Press the "INFO" button (pos. 3, Fig. 52) for at least 1 second for the "Information menu" to open, displaying some boiler operation param-
eters.
To scroll through the various parameters, press the "INFO" button (pos. 3, Fig. 52) and then press 'MODE' to display the value.
To go back to the previous screen or exit the menu, press "RESET" (pos. 4, Fig. 52), or wait 15 minutes.
Parameter ID
d.0
Not used
d.1
Displays the flame signal
d.2
Displays the primary heat exchanger outlet instant CH flow temperature (°C)
d.3
Displays the instant output temperature from the DHW heat exchanger (°C)
d.4
Displays the values set for central heating set
d.5
Displays the values set for DHW set
Displays the external environment temperature (°C) (if optional external probe present). If the temperature is below zero, the
d.6
value is displayed flashing.
d.7
Display the temperature of the inlet DHW (°C)
d.8
Displays the system return water temperature (°C)
d.9
Displays the list of the last 5 faults (to scroll through the list, turn the "CH temperature control" knob)
Anomaly list reset. Once "d.10" is displayed, press MODE; the display shows "--". Then press MODE again for at least 3 seconds;
d.10
deletion is confirmed via the "88 88" symbols flashing for two seconds.
d.11
Not used
d.12
Displays the pump operating speed
d.13
Displays the DHW flow rate (l/min)
d.14
Displays the pump flow rate (l/h)
d.15
Displays the fan operating speed (rpm)
d.16
Displays the temperature read on the flue probe (°C)
d.17
Displays the calculated flow temperature (°C)
d.18
At the end of the screed heater function, displays for how many hours the flow temperature remained at "Top set"
d.19
Displays alternately safety software version, functional software version and MMI display version
d.20
Displays the flow temperature of zone two (°C) (optional)
d.21
Displays the flow temperature of zone three (°C) (optional)
d.22
Insufficient
d.23
DHW gas valve operation hours (x10)
d.24
C.H. gas valve operation hours (x10)
d.25
Ignition cycle number (x10)
d.26
Not used
d.27
Not used
78
Description
Advertisement
Table of Contents
