Assembling The Manifold On The Condensation Module - Immergas VICTRIX MAIOR 28 Instructions And Recommendations

3.27 ASSEMBLING THE MANIFOLD ON THE CONDENSATION MODULE

1. Set the manifold on the module.
2. Tighten the 4 nuts (1) on the condensation module (3) according to the sequence (A, B, C, D) indicated in the drawing.
The tightening torque when assembling the manifold (2) on the condensation module (3) must be 4 Nm.
Do not exceed 5 Nm.
A
D
C
B
3
2
1
95
123