Table of Contents
Advertisement
Make sure to fill the flue gas non-return valve siphon with water (Fig. 44):
6. Fit the bends with male side (smooth) (5) in the female side of the flanges (3 and 4).
7. For intake from shaft (C
ternal wall sealing plate (7) has already been inserted. For wall intake (C
the female side of the bend (5) up to the end stop, ensuring that the internal (7) and external (8) wall sealing plates are fitted.
8. Connect the Ø 80 drain pipe making sure to have already inserted the internal wall sealing plate (7) inside the end section of the pipe.
For maximum extension of the Ø 80/80 terminals and for the installation dimensions, refer to the figures (Fig. 42 - 43).
For the development of the exhaust terminals, a maximum resistance of 19.5 is considered; to calculate the resistance factor,
refer to the relative tables (Parag. 1.14).
9. Set parameter F.1 = 1.
10. Perform the automatic calibration procedure (Parag.3.10).
7
The kit includes (Fig. 41):
No.1 Exhaust gasket (1)
No.1 Flange gasket (2)
No.1 Female intake flange (3)
No.1 Female exhaust flange (4)
No.2 Bend 90° Ø 80 (5)
No.1 Extension Ø 80 (6) (C10 only)
50
) i.e. from common intake duct, connect the intake ducts Ø 80 (6) to the bend (5), making sure that the in-
(10)
5
S
9
10
4
1
), fit the intake terminal (6) with the male side (smooth) in
(12)
6
5
A
6
3
2
No.1 Intake terminal Ø 80 (6) (C12 only)
No.2 Internal wall sealing plates (7)
1
External wall sealing plate (8) (C12 only)
No.1 Exhaust pipe Ø 80 (9)
N°1 Non-return valve on flue gas Ø 80) (10)
N.B.: remove extension Ø 125
7
C10
A
7
8
C12
A
C
- C
10
12
41
Advertisement
Table of Contents
