Table of Contents
Advertisement
Before ignition make sure the heating system is filled with water and that the manometer (7) indicates a pressure of 1 - 1.2 bar
cold.
Operation without Comando Amico Remoto remote control
- Open the gas isolation valve upstream from the appliance.
To activate a command, first activate the keyboard (by pressing any button), then press the desired button and activate the de-
sired function.
• If the boiler is in OFF mode (
Press the 'MODE' button (2) in succession to cycle through the status:
- DHW + C.H. (
+
);
- DHW ONLY (
);
- CH ONLY (
).
DHW mode ONLY (ON) (
In this mode the boiler functions only to produce the DHW, the temperature is set via the knob (5) and the relative temperature is shown
on the display via the indicator (23).
C.H. mode ONLY (ON) (
In this mode the boiler functions only for room central heating, the temperature is set via the knob (6) and the relative temperature is
shown on the display via the indicator (14).
DHW + C.H. mode (ON) (
In this mode, the boiler functions both for producing domestic hot water and heating the environment. The temperature of the DHW is
always regulated via knob (5), the central heating temperature is regulated via knob (6) and the relative temperatures are shown on the
display by the indicators (14-23).
If both CH and DHW are requested at the same time, the boiler will give priority to the DHW request and central heating will not be
available until the DHW request is completed.
Each time the burner ignites, the relative Flame Present symbol is displayed (21) with relative output scale.
Operation with Comando Amico Remoto
If the CAR
is connected, the symbol (
V2
status from the remote control and a fault will be displayed on the remote control. To reactivate the boiler, press the button (1). Once
reactivated, the boiler control parameters can be set from the control panel of the CAR
flashing), press the button (1) again to activate it. If not, go to the next point.
)
)
+
)
(CAR
) (optional)
V2
V2
) appears on the display. If the boiler is in OFF (
.
V2
.
V2
flashing), it is not possible to change this
69
Advertisement
Table of Contents
