Monitor; Emi Screen - Digital Equipment VAXstation I Service Manual

RB PLACEMENT
5. Turn-on system and monitor power.
run.
Microverify should
6. Run Macroverify.
4.8 MONITOR
4.8.l
~onitor Cover Removal
l. Place the monitor on its CRT face on a level work
surfacl!.
WARRING - CRT Face
The integral CRT bezel is designed to keep the
CRT face above the work surface; however, the
work surface under the CRT face should be clear
of any debris. In addition, it is recommended
that rough work surfaces be covered to prevent
any unnecessary scratches on the bezel.
2. To remove the tilt-swivel base from the monitor cover,
remove the four mounting feet from the monitor. The
mounting feet are finger tight.
3. Remove the four philips-head screws from the rear of the
cover.
4. Lift the cover off the monitor compartment.
4.8.2 EMI Screen
WARNING - CRT Neck
With the EMI screen removed, the neck of the CRT
is exposed and can be broken. Be very careful
when removing modules or passing tools over the
monitor compartment.
1. With the cover removed, place the monitor in its normal
viewing position.
2. Loosen the· six screen hold-down screws.
3. Remove the EMI screen.
4-36