Table of Contents
Advertisement
REPLACEMENT
4.
Reconnect (Figure 4·25):
a.
Jl
b.
J2
c.
J4
Power supply cable
10-pin connector
10-pin connector
5.
Replace the
disk
drives
as
described
in
subsection
4.2.3,
steps 3 and 5, and subsection 4.2.5, steps 1 and
2.
6.
Making
sure
that
the
connectors
(Figure
4-24)
are
properly aligned, reconnect:
a.
J6
b.
J2
c.
J7
RXSO
signal cable
RD52 signal cable
RD52 signal cable
7.
Re-install
the
backplane
modules
as
subsection 4.1.2, steps 2, 3, and 4.
described
in
8.
Refasten the Patch and
Filter
Panel
assembly
captive.
screws.
9.
Replace the backplane modules cover.
10.
Replace the storage subsystem cover.
11.
Slide the system unit into the enclosure.
12.
Install the rear chassis retaining bracket.
13.
Reconnect any removed cables to
the
Patch
and
Filter
Panel assembly.
14.
Replace the front and rear covers.
15.
Turn-on system and monitor
power.
run.
16.
Run Macroverify.
4-26
Microverify
should
Advertisement
Table of Contents
