Table of Contents
Advertisement
Install Operators
A. Install End Caps.
1. Secure end caps to each end of connected
backplates using four (4) (two each) #8-32 x
5/16" Phillips pan head screws. (Figure 9)
NOTE: Orient end caps so that text on labels
is legible when observed from ground.
B. Install Operator LAPs.
NOTE: Backplates are printed with text to assist
installation.
1. With backplates mounted to frame, use text
to locate holes along bottom of backplates
that correspond to your specific closer
installation -6061/6071 plus open angle
for left door and 6011/6051 for right door.
(Figure 10)
2. Insert two (2) 1/4-20 x 1/2" Phillips pan head
screws on each backplate into appropriate
engraved locations. Leave a 5/16" minimum
gap between backplate and underside of
screw head.
3. On each backplate, orient LAP so spring
tube of closer is pointed toward closest
hinge edge of frame. Slide each LAP over
two (2) screws and tighten. (Figure 11)
NOTES:
y LAP for left door should have "PUSH"
label and door closer valves should point
toward chain. LAP for right door should
have "PULL" label and door closer valves
should point away from chain.
y When properly oriented, spring tube is at
top on left hand backplate (Figure 11) and
at bottom on right hand backplate.
4. For each LAP, use six (6) 1/4-20 x 1/2" Phillips
head screws to secure. (Figure 12)
NOTES:
y Holes in LAP align with threaded holes in
backplate.
y Screws to be torqued to 80 in-lb mini-
mum.
8
D6001DE-L Series Double Egress Power Operator Unit
Copyright © 2023, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in part
without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Approved 2023-11-10
Figure 9
Figure 10
Operator LAP
Mounting Screws
Right Door LAP shown
Figure 11
Remaining LAP Mounting Screws - Right Door View
Figure 12
Spring Tube
(at bottom
of backplate)
80-9360-1048-020 Rev 1 01/23
Advertisement
Table of Contents
