Assa Abloy Corbin Russwin DC5200 Installation Instructions Manual

Installation Instructions
DC5200 Cam Action Door Closer
Push and Pull Side, Door and Frame Mounted
Non-Hold Open and Hold Open Applications
CAUTION
An incorrectly installed or improperly adjusted door closer can cause
property damage or personal injury. These instructions should be
followed to avoid the possibility of misapplication or misadjustment.
Hold open units are not permitted to be installed in fire door assemblies.
NOTES:
‒ For special applications a separate door and frame preparation template
is packed with these instructions.
‒ Use this instruction sheet for installation sequence and closer adjust-
ments only.
‒ Use of an auxiliary door stop is always recommended.
Pull Side Door Mount
Right Hand Door - RH
Left Hand Reverse - LHR
Pull Side Frame Mount
754F80 Back Plate required if frame is less than 3" (76mm).
Right Hand Door - RH
Left Hand Reverse - LHR
Included Components
Closer Body
Power
Adjustment
Shaft
Full Cover
with Insert
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2023, 2024, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA
ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Standard Applications
Left Hand Door - LH
Right Hand Reverse - RHR
Optional Applications
Left Hand Door - LH
Right Hand Reverse - RHR
Closer Body
Screw Pack
Spring Stop
Slide Track
Arm
Slide Track
Assembly
Approved 2024-03-15
READ AND FOLLOW ALL INSTRUCTIONS.
SAVE THESE INSTRUCTIONS.
The closing force for Series DC5200 door closers is adjustable
from a size 1 to a size 6, as outlined in ANSI Standard A156.4.
When these series of door closers are installed and adjusted
to conform to ADA reduced opening force requirements
(5 lbs max.) for interior doors, they may not have adequate
closing force to reliably close and latch the door. Power
adjustments charted on page 2 are recommended where
possible, to ensure proper door control.
Push Side Frame Mount
Right Hand Door - RH
Left Hand Reverse - LHR
Push Side Door Mount
754F93 Angle Bracket required.
Left Hand Door - LH
Right Hand Reverse - RHR
Hold Open Device
(Standard with Hold
Open model)
Spline Shaft
Screw Pack
Track Mounting
Screw Pack
FM806 Rev 3 03/24
80-9352-0002-152
Left Hand Door - LH
Right Hand Reverse - RHR
Right Hand Door - RH
Left Hand Reverse - LHR
Optional Components
754F93
Slide Track
Angle Bracket
(required for push
side door mounted
applications)
754F80 Back Plate
(required for pull side frame
mounted applications)