Sync Cable For Double Doors (Synchronizing Of 2 Operators) - Assa Abloy Norton 5900 Series Installation And Instruction Manual

Sync cable for double doors (synchronizing of 2 operators)

P/N: 59000CAB
How to cut the jumper for double doors
Opening
Synchronous
Synchronous
Asynchronous
Double egress
Astragal
Settings for double doors
Common
Opening time
Closing time
Hold-open time
Close/continue to open when the door is obstructed
PAG On/Off
Level of Power Assist
Extended closing force
OPD Input or Mat Logic Input
Individual
Fail Secure/Fail Safe Locking
Lock release (Enable/Disable)
Open Delay Time
Latch Speed (Fast/Slow)
*For "Double egress doors", these functions must be set separately for Master and
Slave as the arm systems as well as the air pressure may be different.
Notes:
• Locks on the "Master" and "Slave" doors must be connected to the Control
Unit on the corresponding operator.
• The OPD is to be connected to the "Master" Control Unit except for "Double egress",
where each OPD must be connected to corresponding Control Unit.
• Door leaf mounted sensors must always be connected to corresponding Control Unit.
Copyright © 2010, 2014 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
MASTER SLAVE
Function Door Design
Closing Astragal
Synchronous
No
Asynchronous
Yes
Asynchronous
Yes
—
Jamming
Function
Note:
The markings on the sync cable
determine which of the operators is the
master and slave. Cable length - 10 feet.
Cutting Jumper
Jamming Master
No cutting
No
No Cut black
No cutting
Yes
—
Cut black
No jamming
Master
X
X
X
X
X
X
X
X
Master
X
X
X
X
11
ASSA ABLOY
Slave
No cutting
No cutting
Cut red
Cut red
Settings
Slave
X ( * )
X ( * )
Slave
X
X
X
X
80-9359-0001-020 (01-14) Rev 3