Table of Contents
Advertisement
B. Mount Backplates.
1. Select backplate with 2 small "fingers" for
interlocking plates and marked "Mount
This Plate First" from Box 1. (This is LEFT
backplate.)
2. Slide left backplate over mounting screws.
(Figure 4)
NOTE: Left backplate conduit slot is ALWAYS
at bottom of plate and toward center of
opening.
3. Use level in backplate to align then tighten
mounting screws. (Figure 4)
4. Interlock right backplate (3 small "fingers")
from Box 2 with left backplate. (Figure 5)
NOTE: Right backplate conduit slot is
ALWAYS at bottom of plate and center of
OR
opening.
5. Use level on right backplate to ensure
proper alignment. (Figure 5)
6. Using backplate as template, mark conduit
slot and Dim D mounting hole. (Figure 5)
NOTE: Dim D should be 1" up from frame
rabbet if backplate is properly aligned.
7. Drill hole for mounting screw at Dim D.
8. Using supplied backplate screw pack in Box
2, insert screw into prepared mounting hole.
(Figure 6)
For Metal Frame: Use one (1)
1/4-20 x 1" flat head machine screw.
For Wood Frame: Use one (1)
#14 x 1-1/2" oval head self-drilling screw.
NOTE: Do not tighten mounting screw at
this time. Leave 5/16" minimum (thickness of
backplate) between frame face and back of
screw head.
9. Using countersunk holes in backplates as
a template, drill/tap remaining eleven (11)
mounting holes: 1/4-20 for steel frame or #14
for wood frame. (Figure 6)
6
D6001DE-L Series Double Egress Power Operator Unit
Copyright © 2023, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in part
without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Approved 2023-11-10
Two Fingers
Built-in Level
Figure 4
Built-in Level
Door Size
Dim D
Pair of 36" doors:
30-9/16" (776mm)
Pair of 38" doors:
32-9/16" (827mm)
Pair of 40" doors: 34-9/16" (878mm)
Pair of 42" doors:
36-9/16" (929mm)
Pair of 44" doors:
38-9/16" (979mm)
Pair of 46" doors:
40-9/16" (1030mm)
Pair of 48" doors: 42-9/16" (1081mm)
Figure 5
Remaining Mounting Holes
Figure 6
Conduit Slot
Dim D
First Mounting
Screw
80-9360-1048-020 Rev 1 01/23
Advertisement
Table of Contents
