Package Contents; Preparation; Mark Horizontal Centerline Of Device; Install Trim (If Furnished) - Assa Abloy Corbin Russwin ED8200A Series Installation Instructions Manual

ED8200A Series
Fire-Rated Rim Exit Device
Installation Instructions
2

Package Contents

ED8200A
Latch Assembly
Rear Bracket
Strike, UL
Front Bar Insert
Rear Cover
Front Cover
Non-Reinforced Door
3

Preparation

a

Mark Horizontal Centerline of Device

Establish a centerline of device by drawing a line across the door and the door stop, 40-5/16" (1.02 m)
above finished floor unless doors have been pre-prepped. (Figure 2)
b

Install Trim (If Furnished)

See separate trim installation instructions.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2011, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Qty . Description
6 #12-24 x 7/8" Phillips flat head machine screws
#12-24 x3/4" Phillips pan head machine screws, and #12 internal
2 washers (wood doors #12 x 1-1/4" Phillips pan head, type A, tapping
screws)
4 #12-24 x 7/8" Phillips flat head machine screws
1 #8-32 x 1" Phillips pan head machine screw
1 #8-32 x 1" Phillips flat head machine screw with external washers
#8-32 x 1/2" Phillips flat head machine screw, type F, with external
2
washers
4 #12-24 x 1-21/32" sex nuts
Of Device
40-5/16"
(1.02 m)
Finished
Floor Line
Figure 2
Of Strike
Jamb
Door
3
FM124B 04/20