Table of Contents
Advertisement
E. Connect Power Module Sub-assemblies to LAPS.
Power module wiring may loosen during
shipping. Gently tug each wire on the
connector. If a wire is loose, push the
connector tab and reinsert wire. Release tab
and verify the wiring is secure. (Figure 17)
Operator LAP
3 Pin White
Connector
Operator LAP
10 Pin Black
Connector
F. Install Union Assembly.
1. Orient union assembly so access door
covering selector mode switches faces floor.
(Figure 18)
2. Secure union assembly to backplate using
four (4) #8-32 x 5/16" Phillips pan head
screws. (Figure 18)
3. Connect 4-pin black square connector from
power module sub-assembly to 4-pin black
connector from union assembly for each
operator. (Figure 19)
NOTE: Connectors are keyed and only
assembly one way.
10
D6001DE-L Series Double Egress Power Operator Unit
Power Module
Sub-assembly
3 Pin White
Connector
Power Module
Sub-assembly
10 Pin Black
Connector
Power Module
Sub-assembly
4 Pin Black
Connector
Figure 19
Copyright © 2023, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in part
Approved 2023-11-10
1. Attach 10-pin black connectors between each power
module sub-assembly and its operator LAP. (Figure 16)
NOTE: Connectors are keyed and only attach one way.
2. Attach 3-pin white connectors between each power
module sub-assembly and its operator LAP. (Figure 16)
Power Module
Sub-assembly
10 Pin Black
Connector
Power Module
Sub-assembly
3 Pin White
Connector
Figure 16
Spacer
Union Assembly - View From Floor
Figure 18
Union Assembly
4 Pin Black Connector
without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Operator LAP
10 Pin Black
Connector
Push tab to open
Operator LAP
3 Pin White
Connector
Spacer
Union Assembly
Mounting Screw
(typical)
Access Door
Power Module
Sub-assembly
4 Pin Black
Connector
80-9360-1048-020 Rev 1 01/23
wire channel.
Figure 17
Advertisement
Table of Contents
