Basic Operating Instructions; Switching The Projector On; Switching The Projector Off; Interlock Reset - Delta DIJITAL PROJECTION M-Vision 21000 II WUXGA Series Important Information Manual

Basic Operating Instructions

Basic Operating Instructions
See Control panel on page 51 for guidance on using the control panel to
control the projector.
See Remote control on page 54 for guidance on using the remote control to
control the projector.

Switching the projector on

1. Make sure a lens is fitted. Connect the power cable between the mains supply
and the projector.
2. Switch on at the switch next to the power connector.
The POWER indicator lights red to signal that the projector is in STANDBY
mode.
3. Press one of the following buttons:
On the remote control, the ON button
l
On the projector control panel, the POWER button.
l
The POWER indicator begins flashing green and the fans start working. When the
flashing stops and the POWER and LIGHT indicators both light steady green, the
projector is switched on.

Switching the projector off

1. Press OFF on the remote control or POWER on the control panel, then press
again to confirm your choice.
The POWER indicator on the control panel will start flashing amber, the system
will go out and the cooling fans will run for a short time until the POWER
indicator goes steady red to indicate that the projector has entered STANDBY
mode.
2. If you need to switch the projector off completely, switch off at the mains power
switch next to the power connector and then disconnect the power cable from
the projector.

Interlock reset

In the event of the laser illumination turning off as a result of an Interlock break:
1. Make sure all interlocks are in place. See Interlock Switches on page 29
2. Turn ON the laser illumination. See Switching the projector on above
Important Information
Digital Projection Ltd.
M-Vision 2X000 Series WUXGA
Rev A December 2023
page 47