Table of Contents
Advertisement
Installation Precautions
Make sure the lens cap is removed from the lens before operating the
projector. Light energy levels have been known to cause damage to both
the lens and projector optics. This damage is not covered by our warranty.
Make sure the lens cap is removed from the rear of the lens before it is
inserted into the projector.
Connect the LAN cable only to a computer LAN connection. Other similar
connectors may have a dangerously high voltage source.
The power cord and signal cable should be connected before the projector
is powered on. During startup and operation, DO NOT insert or remove the
signal cable or the power cord to avoid damaging the projector.
Turn on High Altitude Mode when located in high altitude areas.
The projector generates heat during use. The internal fans dissipate the
heat of the projector when shutting down, which could continue for a certain
period. After the projector enters STANDBY MODE, remove the power cord.
DO NOT remove the power cord during shutdown as it may cause damage
to the projector and may affect the service life of the projector.
Do not place heavy objects on top of the projector chassis. Only the chassis
corners and the optional rigging frame are capable of withstanding the
weight of another projector.
Important Information
Digital Projection Ltd.
M-Vision 2X000 Series WUXGA
Rev A December 2023
page 33
Advertisement
Table of Contents
