Table of Contents
Advertisement
Installation Precautions
When using projectors in environments with third party high power laser
systems avoid direct laser beams pointing towards the projection lens. This
may cause incident light to converge into the optical engine and cause
damage to the DLP™ DMD™.
Before installation, make sure that the surface, ceiling or rigging that is to
support the projector is capable of supporting the combined weight of the
projector and lens.
Backup safety chains or wires should always be used with ceiling mount
installations.
When installing a ceiling mount, make sure the weight limit is not exceeded
and the projector is firmly secured.
When stacking projectors, the stack MUST be vertical, to ensure that the
stresses are distributed to all four chassis corners.
Do not stack more than 2 projectors.
The projector can be operated any position, as shown in the diagram:
Important Information
Digital Projection Ltd.
360˚
Tilt (Left) and Roll (Right)
M-Vision 2X000 Series WUXGA
360˚
Rev A December 2023
page 31
Advertisement
Table of Contents
