Table of Contents
Advertisement
M-Vision 2X000 Series WUXGA
Laser Hazard Installation Precautions
Do not attempt to access the internal hardware of the projector. Do not a
attempt to modify or remove the laser module.
Do not operate the projector without its protective covers.
Please consult with a qualified professional to install or remove the lens.
This projector is a Laser Risk Group 2 product when a lens with a throw ratio
less than 1.2: 1 is installed. It becomes Laser Risk Group 3 when a lens with a
throw ratio greater than 1.2 :1 is installed.
Please note that the REF model is always classed under Laser Risk Group 2.
Laser Risk Group 2 Installation
This product is a Class 1 Risk Group 2 laser product. It must be installed in
a safe place.
The product should be installed and operated in accordance with the
provisions of BS EN IEC 62471-5:2015 and the Important Information
document or User Manual
Do not operate the projector without a lens installed.
MOUNT ABOVE THE HEAD HEIGHT OF CHILDREN. It is recommended to
use a ceiling mount to place this product above the eyes of children.
Laser Risk Group 3 Installation Precautions
This product is a Class 1 Risk Group 3 laser product. It must be installed in
a safe place and must be handled by qualified and professionally trained
personnel.
Operators shall control access to the beam within the hazard distance or
install the product at a height that will prevent exposure of the spectator's
eyes within the hazard distance.
The product should be installed and operated in accordance with the
provisions of BS EN IEC 62471-5:2015 and the Important Information
document or User Manual by instructed and skilled persons only (BS EN
IEC 62368-1:2020).
Rev A December 2023
page 34
Laser Hazard Installation Precautions
Important Information
Digital Projection Ltd.
Advertisement
Table of Contents
