Signal Connections - Delta DIJITAL PROJECTION M-Vision 21000 II WUXGA Series Important Information Manual

M-Vision 2X000 Series WUXGA

Signal connections

1. Sync In
3D sync input signal. Use a BNC connector to connect the 3D sync from your
graphics card or server.
2. Sync Out
3D sync output signal. This enables synchronized 3D with multiple projectors.
Use a 3-pin DIN connector to connect this to another projector.
3. HDBaseT (Optional board)
Receives digital signal from HDBaseT-compliant devices. Cat 6A cable is
recommended.
4. HDMI 1 / HDMI 2
HDMI 2.0 inputs supporting HDCP 2.2 and Frame Sequential, Top and
Bottom, Side By Side and Frame packing 3D formats. Connect an HDMI cable
to the connector.
5. SDI in
SDI input supporting up to 12G-SDI. Connect an SDI cable to the connector.
6. DisplayPort 1 / DisplayPort 2
DisplayPort 1.2 input. Connect a DisplayPort cable to the connector.
7. 3D Sync IR
Sync output signal. Connect this to an IR emitter or ZScreen.
8. SDI out
SDI output supporting up to 12G-SDI. Connect an SDI cable to distribute the
SDI signal to another projector.
Rev A December 2023
page 44
1 2 3 4 5
Signal connections
6 7
Important Information
Digital Projection Ltd.
8