Table of Contents
Advertisement
M-Vision 2X000 Series WUXGA
Installation Precautions
The projector must be installed only by suitably qualified personnel, in
accordance with local building codes.
The projector is heavy. Use safe handling techniques when lifting the
projector.
Do not drop or knock the projector.
Do not install the projector close to anything that might be affected by its
operational heat, for instance, polystyrene ceiling tiles, curtains etc.
Place the projector in a dry area away from sources of dust, moisture,
steam, smoke, sunlight or heat.
Ensure that the intake vents do not recycle hot air from the exhaust vent.
When operating the projector in an enclosed space, ensure that the
surrounding air temperature within the enclosure does not exceed
operation temperature while the projector is running, and the air intake and
exhaust vents are unobstructed.
All enclosures should pass a certified thermal evaluation to ensure that the
projector does not recycle exhaust air, as this may cause the device to
shutdown even if the enclosure temperature is with the acceptable
operation temperature range.
Avoid installing at high temperature, insufficient cooling and heavy dust
locations.
Keep your product away from fluorescent lamps (>1 Meter) to avoid
malfunction caused by IR interference.
Avoid installing near an air conditioner duct or a subwoofer.
The projector should be installed as close to the power outlet as possible.
The power connection should be easily accessible, so that it can be
disconnected in an emergency.
Please pay attention to projector installation with respect to other staging
laser light equipment set-up. These systems can cause permanent damage
to the DMD™ imaging devices used in our projectors. This damage is not
covered by our warranty.
Rev A December 2023
page 30
Installation Precautions
Important Information
Digital Projection Ltd.
Advertisement
Table of Contents
