Selecting An Input Signal; Selecting A Test Pattern - Delta DIJITAL PROJECTION M-Vision 21000 II WUXGA Series Important Information Manual

M-Vision 2X000 Series WUXGA

Selecting an input signal

1. Connect one or more image sources to the projector.
2. Select the input you want to display:
Press one of the input buttons on the remote control or control panel.
l
Alternatively, open the On-screen display (OSD) by pressing MENU.
l
Highlight Input from the main menu, press ENTER/OK and then select
an input signal using the UP and DOWN arrow buttons. Press
ENTER/OK to confirm your choice.

Selecting a test pattern

The following test patterns are available: Off, White, Black, Red, Green, Blue,
Checkerboard, Crosshatch, Color Bar, Aspect Ratio
Use one of the following methods to display a test pattern:
Press TEST on the remote control.
l
Use the LEFT and RIGHT arrow buttons to cycle through the test patterns.
Press MENU open the OSD. Highlight Test Patterns from the main menu, then
l
select a test pattern using the LEFT and RIGHT arrow buttons.
After the final test pattern, the projector exits test pattern mode and returns to the main
image. To view test patterns again, you need to press TEST again. If you wish to exit
the test patterns before you reach the final one, press TEST or EXIT at any time.
Rev A December 2023
page 48
Basic Operating Instructions
Important Information
Digital Projection Ltd.