Stacking; Pin And Cup Stacking - Delta DIJITAL PROJECTION M-Vision 21000 II WUXGA Series Important Information Manual

Stacking

Stacking
The projectors must be in a vertical position when they are stacked. This
will ensure that the stresses are distributed to all four corners of the
chassis.
Do not use the threaded holes for the adjustable feet to hang or mount the
projector.
Do not use the carry handles to hang or mount the projector.
Do not stack more than 2 projectors.
Use only the provided screws with a torque of 25-30 kgf cm (2.45 - 2.94 Nm).
It is the customer's responsibility to ensure that the assembly is carried out
securely.

Pin and cup stacking

1. Remove the four screws on the
top side of the projector that
will be on the bottom of the
stack.
Important Information
Digital Projection Ltd.
M-Vision 2X000 Series WUXGA
Rev A December 2023
page 41