Laser Safety Precautions
Laser Safety Precautions
Warning! Death or Serious Injury could occur if the following precautions
are ignored
Permanent/Temporary Blindness Hazard
Do not look directly into the lens when the light source is on. The high
brightness can cause permanent eye damage.
Caution – use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
Do not attempt to operate the product without covers in place.
Lens Change should only be carried out by instructed and skilled persons in
accordance with the Important Information document or User Manual. If in
doubt consult your dealer.
Ensure the projector is switched off and AC power removed before
attempting a lens change
This projector is a Laser Risk Group 2 product when a lens with a throw ratio
less than 1.2: 1 is installed. It becomes Laser Risk Group 3 when a lens with a
throw ratio greater than 1.2 :1 is installed.
Please note that the REF model is always classed under Laser Risk Group 2.
Laser Risk Group 2 Precautions
Class 1 Laser Product, BS EN IEC 60825-1:2014.
Caution! As with any bright source, do not stare directly into beam, RG2 IEC
62471-5:2015.
The product should be installed and operated in accordance with the
provisions of BS EN IEC 62471-5:2015 and the Important Information
document or User Manual
Children should be supervised and never be allowed to stare into the
projector beam at any distance from the projector.
Use caution when using a remote control to switch the projector on when
standing in front of the projection lens.
Important Information
Digital Projection Ltd.
M-Vision 2X000 Series WUXGA
Rev A December 2023
page 13