Table of Contents
Advertisement
References
Multiple Labels Ordering by Code Symbology
This feature Specifies the transmission ordering by symbology type, when Multiple Labels per Frame is enabled.Up
to six symbologies can be selected. Zeroes must be added to pad the string to 12 characters if not using all six
symbologies.
The labels are ordered first as specified in the output mask. Labels present in the volume but not specified will be
transmitted as unspecified symbologies in random order as allowed by the reading time sequence. For each label
decoded in the volume the reader signals the standard beeper and LED indications.
To specify the symbology order:
1. Determine the symbologies and order you want to specify.
2. Use
Table 44 on page 235
3. Go to
page 80
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
Mode.
4. Scan the bar code: "SELECT SYMBOLOGIES FOR MULTIPLE LABELS ORDERING".
5. Scan the appropriate two alphanumeric characters from the keypad in
the desired character/value in step 2 above.
6. Scan zeroes if needed to make a 12-character string.
7. When finished, scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See
Table 43. Multiple Labels Ordering by Code Symbology Examples
STEP
ACTION
1
Desired symbology
Hex equivalent from
2
Chart
3
4
Scan Two Characters From
5
Appendix D, Keypad
RESULT
6
Table 44 on page 235
shows the hex value associated with each symbology.
234
to find the
hex values for up to six symbologies.
Table 43
for some examples of how to set this feature.
Code 39
ASCII
24
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT SYMBOLOGIES FOR MULTIPLE LABELS ORDERING
'2' and '4'
0x240E0C4E0000
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D,
EXAMPLES
Data Matrix
Code 128
0E
0C
'0' and 'E'
'0' and 'C'
Keypad, that represent
Aztec
4E
'4' and 'E'
QuickScan™ I QD24XX
Advertisement
Table of Contents
