References
Scanning Features
Scan Mode
This mode is associated with typical handheld reader operation. Selects the scan operating mode for the reader. The
following selections are valid for all models:
Trigger Single:
When the trigger is pulled, scanning is activated until one of the following occurs:
-
Scanning Active Time
- a label has been read
- the trigger is released
Trigger Hold Multiple:
or
Scanning Active Time
undesired multiple reads of the same label while in this mode.
Trigger Pulse Multiple:
has elapsed or the trigger has been released and pulled again.
reads of the same label while in this mode.
Flashing:
The reader flashes on and off regardless of the trigger status. Flash rate is controlled by
and
Flash Off
Time. When Flash is ON the imager reads continuously; when Flash is OFF scanning is deactivated.
Always On:
No trigger pull is required to read a bar code. Scanning is continually on. If the trigger is pulled, the
reader acts as if it is in Trigger Single Mode.
label while in this mode.
Stand Mode:
No trigger pull is required to read a bar code. Scanning is turned on automatically when an item is
placed in the reader's field of view. If the trigger is pulled, the reader acts as if it in single read mode.
Timeout
prevents undesired multiple reads while in this mode.
228
has elapsed
When the trigger is pulled, scanning starts and the product scans until the trigger is released
has elapsed. Reading a label does not disable scanning.
When the trigger is pulled, continuous scanning is activated until
Double Read Timeout
Double Read Timeout
Double Read Timeout
prevents undesired multiple reads of the same
prevents
Scanning Active Time
prevents undesired multiple
Flash On Time
Double Read
QuickScan™ I QD24XX