Table of Contents
Advertisement
Reading Parameters
Good Read LED Duration
This feature specifies the amount of time that the Good Read LED remains on following a good read. The good
read LED on time can be set within a range of 10 milliseconds to 2,550 milliseconds (0.001 to 2.55 seconds) in
100ms increments.
Follow these instructions to set this feature:
1. Determine the desired setting in milliseconds. A setting of 0 means that the good read LED stays on until the
next time the trigger is pulled.
2. Divide the desired setting by 10 (setting is in 100ms increments). Pad the result with leading zeroes to yield
three digits. For example: 0 = 000, 5 = 000, 20 = 020, etc.
3. Go to
page 68
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
Mode.
4. Scan the bar code: SELECT GOOD READ LED DURATION SETTING.
5. Scan the appropriate three digits from the keypad in
was determined in the steps above. You will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to abort and not save
the entry string. You can then start again at the beginning.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See
Table 37. Good Read LED Duration Setting Examples
STEP
ACTION
1
Desired Setting
Divide by 10 (and pad with
2
leading zeroes)
3
4
Scan Three Characters From
5
Appendix D, Keypad
6
Product Reference Guide
Table 37
for some examples of how to set this feature.
Good Read LED
stays on until next
trigger pull (00)
000
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT GOOD READ LED DURATION SETTING
'0' , '0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D, Keypad
representing the duration which
EXAMPLES
20ms
150ms
002
'0' , '0' and '2'
'0' , '1' and '5'
Reading Parameters
2550ms (2.55 sec.)
015
255
'2' , '5' and '5'
227
Advertisement
Table of Contents
