ABB Terra 94 UL Operation And Installation Manual page 47

Installation
The EVSE can be equipped with two types of cable clamp used to hook the charging cable on the CMS. Follow the
steps below regarding the clamp that is present on the EVSE:
TYPE 1
• Install the cable clamp (53), one on each charging cable,
on the rope of the respective CMS.
53
TYPE 2
• Remove the cable clamp from the CMS by unscrewing
the screw and the hex nut.
• Install the "Clamp insert" on the charging cable (at 8.2 in
(250 cm) starting from the EVSE) and lock it in position
by inserting the 2 springs.
NOTE
Before installing the clamp, some cable types
require a layer of rubber tape between the
charging cable and the clamp. Make sure the
tape is installed properly in order keep a
perfectly round profile without overlapping
with its other end, approximately
• Install the clamp on the cable insert.
• Install the rope holder on the cable clamp.
• Install the screw and the hex nut to secure the holder
and the cable clamp.
47
in gap.
1 / 8